Mygsmtube

I decided to make a video showing how to fully swap housings for the blackberry tour. This video is somewhat long but it\'s very detailed and easy to do. If you have any questions just leave me a message on youtube and i\'ll try my best to help you out. Also if you like the video don\'t forget to rate, comment, and subscribe to see more videos like this from me. [More] [Less]

2700c betty & avimlma changing

successfully replaced uem from water damage 1202 and see alive after replacing.

disassemble nokia 6750.avi

When toying around with a magnet near my 5800 suddenly the display got back to normal. So i decided to put a timy magnet inside my phone ...and it Works. get disassembly guide from here: megaupload.com/?d=XYM50O43 i take no responsibility whatsoever if you damage your phone. don\'t do this if you are not confident OR you still have warranty for your device. have a nice time! BTW : if you have any other problems, (well, not related to chicks) , i will be glad to help you out, so reply in the comments section below!!) [More] [Less]

This is a video tutorial on how you can tighten the loose slider on the Nokia N900. All you need is electrical type and about 10-15 minutes! (Not to mention a Philips PH0 screwdriver) ----- For free mobile themes, wallpapers, and ringtone http://www.tehkseven.net Follow us on Twitter! http://www.twitter.com/tehkseven [More] [Less]

You can find the parts from this website http://www.g-plushk.com/ Disassembly Instruction Guild for Nokia 5800 / 5230 Xpress Music.

Cleaning camera lens in Nokia N96 smartphone. A little bit of disassembly and a little bit of cleaning, nothing very special.

Nokia 6085 Disassembly manual

How to reball bga ic

Disassembly of W580i how to

official fitting instruction for nokia n95

Nokia N95 Disassembly Upper Block

This board was faulty for some undetectable reason so we need to pull the IC off, clean up the PCB and the IC and then mount the IC back on. This video shows heating up the four sides with a circular motion of the air gun and slightly lifting on the IC. We use lead free solder paste so it takes a bit of time for the solder to release. Notice I am not lifting hard enough to raise the PCB - give the IC time to let go of the PCB on its own. [More] [Less]

Nokia E71 disassemble

Ngauge Qd assembly

Nokia 5610 Assembly

how to disassemble the lower block assembly of nokia cellphone model 7370

nokia n82 disassembly

how to disassemble a nokia cellphone model n91

How to Disassembly N73

disassembly nokia 2255 par1

M600 Sony Ericsson Disassembly

N93 upperblock disassembly assembly

N93 lowerblock disassembly assembly

Repair Movie: Disassembly - Front Unit - Screw Covers - Rear Display Housing - Rigid-Flex PCB - Display - Front Cover

Repair Movie: Disassembly - Rear Unit - Battery Cover - Battery - Stylus - Antenna Cover - Main Antenna - Screw Caps - Rear Bottom Housing - BT & GPS Antenna - Main Board - FPC QWERTY Keyboard - Keypad QWERTY - Keypad Cover

p990i disassembly

How to disassemble the SE K610i

Instructions for Soldering and Desoldering SMDs featuring up-close shots of fine-pitch soldering.

How to reball bga ic